Angelcare AC1120 - Manual (Page 13)

1. press the sUB-MenU icon.
2. press the AlArM icon.
3. you can select one of the three following alarm
modes: sound alarm, sound alarm and vibration or
vibration only. the symbol representing your choice
will appear on top of the AlArM icon.
4. press oK to confirm and return to MAin MenU.
sound alarm
sound alarm and vibration
Vibration only
Note: when the “vibration only” mode is selected, the
alarm will not sound on the parents Unit but it will still
sound on the nursery Unit. when the parents Unit is
placed in the charging unit, vibration is disabled and will
temporarily change to sound alarm only mode. during
main menu and settings operations, no sound will be
transmitted to the parents Unit. the alarms and
notifications are temporarily turned off.
2.3 ALARM SET-UP
• Battery capacity icon is always displayed on the lCd
screen top bar.
• when battery capacity is low - the parents Unit will
emit a warning beep every 15 seconds, to indicate that
the batteries need to be recharged.
• Although the batteries at 1/3 capacity will support
normal operations of your monitor, it is highly
recommended to fully recharge the batteries at this
stage (A).
• for fUll battery capacity, you must charge the
parents Unit for a minimum of 10 hours in the parents
Unit cradle.
• while the parents Unit is recharging, the battery icon
will run as shown on (B).
low 1/3 full 2/3 full full
A)
B)
2.4 BATTERY CAPACITY DISPLAY
1. to deactivate the key tone sound, press the Key tone
icon.
2. Choose on or off.
3. press oK to confirm and return to the MAin MenU.
2.5 KEY TONE SETTINGS
13
AC1120 UK A5 05.15.2012 12-05-15 8:12 AM Page 13