AMT Datasouth Accel 7450 - Manual (Page 17)

ACCEL- 7450
- 17 -
See Control Panel on page 19 for instr uctions on using the printer’s
control panel menu.
Note: Fanfold paper size is usually marked on the package
If the paper length is not specified, the page length can be
determined by the number of sprocket holes per sheet.
The number of holes x 0.5 inch equals to the page length. For
example if the sheet has 8 holes then length is 4 inches.
8.
Perform a test print job after connecting the printer to the computer.
Fine adjust the tractor’s side to side position for the desired left
starting print position.
The vertical, starting print position may be adjusted as follows:
Full lines:
Set the “TOP MARGIN” using the printer’s control
panel menu.
Partial Lines: Set “TOF ADJ TRACTOR” using the printer’s
control panel menu. This adjustment has a 1/60
th
inch resolution (0.0166”)