AMT Datasouth FM 4600 plus - Manual (Page 8)

Page 8 of 8
February 2012 Document #140194
Typical Set-up Control Panel Features (features may differ among models)
Feature Item Value Factory Default
PRINT MODE Direct Thermal or Thermal Mode Direct Thermal
MAC ADDRESS ####-####-#### Printer Specific
DEFAULT GATEWAY ###.###.###.### Printer Specific
SUBNET MASK ###.###.###.### Printer Specific
IP ADDRESS ###.###.###.### Client Determined
DHCP Enabled or Disabled Disabled
CLEAR FLASH Yes or No No
LENGTH (RS232) 7 Data Bits or 8 Data Bits 8 Data Bits
PARITY (RS232) None Odd or Even None
BAUD RATE
9600 / 115200 / 57600 / 38400 / 19200
9600 / 4800 / 2400 / 1200 / 600
9600
TRIM DARKNESS -030 ~ +030 +000
ABS DARKNESS 000~030 016
PRESENT DISTANCE 000~040 021
MEDIA SENSOR TYPE Gap or Black Bar Black Bar
COUNTING Up or Down Down
PEELER INSTALLED Yes or No No
CUTTER INSTALLED Yes or No No
RECOVER PRINT Enabled or Disabled Disabled
TPH VERT. OFFSET -003 ~ +003 +000
CUT PEEL OFFSET -015 ~ +050 +000
AUTO CALIBR MODE Mode 1 ~ 4 Mode 1
Notes:
1. To verify that a feature has been properly changed cycle power on the printer.
2. Make sure the settings you desire has an * character by the value.