AMT Datasouth FM 4600 plus - Manual (Page 7)

Page 7 of 8
February 2012 Document #140194
Procedure to Enter into Set-up Mode
1. Power on the printer.
2.
When the “ READY” message is displayed on the LCD, press [PAUSE] once to
enter off-line mode. Press and hold [FEED] and then [PAUSE] buttons. Release
buttons.
3. Press and hold [FEED], then press [PAUSE] button repeatedly to scroll to the
feature that you want to change.
4. Press [CANCEL] button once to select feature.
5. Press and hold [FEED], then press [PAUSE] button repeatedly to scroll to the
desired value of the displayed feature.
6. Once the desired value is displayed, press [CANCEL] button to save it. After
pressing the [CANCEL] button an * should appear in the last column. The * is used
to designate the stored value in non-volatile memory.
7. Press the [PAUSE] button once to save, and again to return to normal mode.
Note: Do not enter set-up mode while the printer is printing or while the host is sending
data.