Delta 16968-DST Series - Manual (Page 11)

11
6
Faucet Inspection and Operation
3
2
1
1
A.
B.
Unlock
Lock
A.
Turn on hot and cold water supplies
(1). Pull the hose assembly (2) out of
the spout and remove the sprayer (3).
Be sure to hold the end of the hose
down into the sink and turn faucet
handle (4) to the mixed position.
Flush water lines for one minute.
IMPORTANT: This flushes away any
debris that could cause damage to
internal parts. Reinstall the sprayer.
Check all connections at arrows for
leaks. Refer back to the appropriate
installation instructions and retighten if
necessary. If assembled correctly,
check for damage to seals and order
appropriate replacements.
B.
Sprayer will lock into position when
brought into proximity of the spout
magnet. The sprayer can be removed by
either pulling directly out from the spout
or by twisting 90° in either direction which
will cause the magnets to repel and the
head to decouple from the spout
(recommended). Check the operation of
the sprayer by operating the trigger (1)
from aerator to spray.
1
4