Step 9: gimbal tuning software – Alwarerc Lensman-Pro 3 Axis DSLR Brushless Gimbal (For Handheld/ DJIS800/ 1000) User Manual
Page 19
STEP 9: Gimbal Tuning Software
Specification for the 32 bits SimpleBGC Camera Stabilizer System with [Lensman-Pro Gimbal]:
Board: version 3.0
Firmware: v2.42 b7 (Can be upgraded via the GUI software easily!)
Tuning Software: SimpleBGC GUI v2.42b7
Input Voltage: 11.1V 3S Lipo with XT-60 Connector (for the Default Setting)
Default PID and Power Setting suitable for: DSLR Camera with Lens 0.8-1.4kg
(Remarks: For other camera out of this range will need to have different PID setting.)
How to connect to the computer?
Step 1.
Download the newest software for 32 bits Controller e.g. “ SimpleBGC_GUI_2_42b7.zip ” at the official website
Step 2.
Connect the Gimbal Control Board to the computer. No battery is needed at the moment. Wait for around 1-2 mins for the driver to be
installed automatically. When the driver has been installed successfully, you will get a notice from your computer.
If your computer fail to install the Driver automatically, download the driver here and install it manually:
19