Alwarerc Lensman-Pro 3 Axis DSLR Brushless Gimbal (For Handheld/ DJIS800/ 1000) - Manual (Page 10)

Tighten these Screws. Holding the Side Fame of the Gimbal. Tilt the Camera in about 45 degrees. Camera
should remain steady there when you release
you hand when the CG is correct.
Loosen total 8pcs Screws as to adjust the Up-
Down position of the camera if the CG is not
correct. (Hold the Camera at the same time)
Adjust the Camera (Up/ Down) and tighten
8pcs Screws again.
Test the CG again in about 45 degrees. Repeat
the previous Steps if the CG is still not
accurate. (Be Patient Here)
10