ADLINK IMB-T10 - Manual (Page 37)

Hardware Information 25
IMB-T10
2.5 Jumper Settings
Clear CMOS Header
CLRCMOS1 allows you to clear the data in CMOS. To clear and
reset the system parameters to default setup, please turn off the
computer and unplug the power cord from the power supply. After
waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on
CLRCMOS1 for 5 seconds. However, please do not clear the
CMOS right after you update the BIOS. If you need to clear the
CMOS when you just fi nish updating the BIOS, you must boot up
the system first, and then shut it down before you do the clear-
CMOS action. Please be noted that the password, date, time, user
default profile and MAC address will be cleared only if the CMOS
battery is removed.
(CLRCMOS1, see p. 14, No. 25)
Backlight PWM
(BLT_PWM1 & BLT_PWM2, see p. 14, No. 8)
Panel Power
(PNL_PWR1 & PNL_PWR2, see p. 14, No. 8)
Pin # Function
1-2 Normal
2-3 Clear CMOS
Pin # Signal
1-2 +3V
2-3 +5V
Pin # Signal
1-2 +3V
2-3 +5V