ADLINK IMB-T10 - Manual (Page 32)

20 Hardware Information
CPU/Chassis Fan Connectors (CPU/CHA__FAN1)
System Panel Header (PANEL1)
PWRBTN (Power Switch): Connect to the power switch on the
chassis front panel. You may configure the way to turn off your
system using the power switch.
RESET (Reset Switch): Connect to the reset switch on the chassis
front panel. Press the reset switch to restart the computer if the
computer freezes and fails to perform a normal restart.
PLED (System Power LED): Connect to the power status indicator
on the chassis front panel. The LED is on when the system is
operating. The LED keeps blinking when the system is in S1/S3
sleep state. The LED is off when the system is in S4 sleep state or
powered off (S5).
Pin # Signal
1 GND
2 Fan power (+12V)
3 Fan Tachometer
4 Fan Speed Control
NOTE: NOTE:
A 3-pin fan connector (no fan speed control) can be connected
to pins 1-3.
1 4