ADLINK NuPRO-A40H - Manual (Page 48)

34 Getting Started
3.4 Installing the Power Connectors
Refer to Section 2.2 Board Layout on page 15 and Section 2.3
Onboard Connectors
on page 16 for detailed information on con-
nectors and pin definitions referred to below.
ATX 12V Power Connector
The NuPRO-A40H requires +12V DC power connected to CN24
for proper operation in either ATX or AT modes. If necessary, order
an ATX12V Convert Cable from ADLINK for use with Molex 4-pin
power connectors (P/N 30-00006-0000).
Front Panel Connector
Before powering up the NuPRO-A40H, connect the necessary sig-
nals from the backplane to the System Panel pin header (CN23).
The ATX Power Connector pin group (pins 6, 8, 9, 10) and Power
Button pin group (pins 19, 20) must be connected for the system
to power up in ATX mode.