ADLINK MXE-200i - Manual (Page 26)

12 Introduction
1.6.6 USB 3.0 Port
The USB 3.0 port supports Type A connection, compatible with
SuperSpeed, Hi-Speed, full-speed and low-speed USB devices,
with support for multiple boot devices, including USB flash, USB
external HDD, and USB CD-ROM drivers and boot priority and
boot device configured in BIOS.
1.7 (Right) Side Panel I/O Connectors
This section describes I/O connectors located on the side panel of
the MXE-200.
Figure 1-6: (Right) Side Panel I/O
Table 1-5: MXE-200 Rear Panel I/O Connector Legend
NOTE: NOTE:
When using USB CD-ROM via USB 3.0 port to re-install or
repair the OS, cold boot should be utilized
A DC power supply connector
B DB-9P COM Ports
A
B