ADLINK nanoX-BASE - Manual (Page 18)

nanoX-BASE User’s Manual Page 18
SDVO from Module to Flat Cable connector CN30
Since COM Express Type 1 and Type 10 only define the AB connector, the CD connector which
brings out SDVO signals from COM Express Type 2~6 modules to the carrier is not available.
The method described below for connecting SDVO signals from the module to the carrier allows
the nanoX-BASE to be compatible with both Type 1 and Type 10 modules.
Type 1
The SDVO signals on a Type 1 module (e.g. nanoX-ML) are brought out through a Hirose FH12-
30S-0.5SH(55), 30-pin FFC/FPC connector on the module. Connect the SDVO signal from the
output connector on the Type 1 module to CN30 on the nanoX-BASE carrier board using the flat
ribbon cable provided.
Maximum routing length from connector to SDVO device is approximately 6”, so a cable
length of up to 4” can be used.
Type 10
The SDVO signals on a Type 10 module (e.g. nanoX-TC) are brought out through the AB
connector to a Hirose FH12-30S-0.5SH(55), 30-pin FFC/FPC connector on the carrier (CNX5).
Connect the SDVO signal from the CNX5 output connector to CN30 on the nanoX-BASE carrier
board using the flat ribbon cable provided.
30
1
CN30
Flat cable Type 1 Module
CN30
Type 10 Module
CNX5
30
1
Flat cable