Usb > chipset usb configuration, Network, Pci and pcie – ADLINK nanoX-BT User Manual
Page 46
Page 46
nanoX-BT
Feature
Options
Description
Device power-up delay
Auto
Manual
Maximum time the device will take before it properly reports itself to
the Host Controller. 'Auto' uses default value: for a Root port it is 100
ms, for a Hub port the delay is taken from Hub descriptor.
Mass Storage Devices
Info only
List current USB mass storage devices.
7.3.5.1. USB > Chipset USB Configuration
Feature
Options
Description
USB Configuration
Info only
USB OTG Support
Enabled
Disabled
Enable/Disable USB OTG support.
USB VBUS
On
Off
VBUS Should be On in Host Mode. It should be Off in OTG
device mode..
XHCI Mode
Enabled
Disabled
Auto
Smart Auto
Mode of operation of xHCI controller.
USB 2.0 (EHCI) Support
Enabled
Disabled
Control the USB EHCI (USB 2.0) functions. One EHCI controller
must always be enabled.
USB Per Port Control
Enabled
Disabled
Control each of the USB ports (0~3). Enable: Enable USB per
port; Disable: Use USB port x settings.
USB Port #0~3
Enabled
Disabled
Enable/Disable USB port 0-3.
7.3.6. Network
Feature
Options
Description
Network Info
only
Network Stack
Enabled
Disabled
Enable/Disable UEFI network stack.
LAN Controller
Enabled
Disabled
Enable/Disable LAN controller.
Wake on LAN
Disable
Enabled
If Enabled: LAN_PWR is always on; If Disabled: LAN_PWR is off
after entering Suspend mode.
7.3.7. PCI and PCIe
Feature
Options
Description
PCI and PCIe
Info only
PCI Common Settings
Info only
PCI Latency
32 PCI Bus Clocks
64 PCI Bus Clocks
96 PCI Bus Clocks
128 PCI Bus Clocks
160 PCI Bus Clocks
192 PCI Bus Clocks
224 PCI Bus Clocks
248 PCI Bus Clocks
Value to be programmed into PCI latency timer register.