ADLINK nanoX-BT - Manual (Page 45)

nanoX-BT Page 45
7.3.4. SATA
Feature Options Description
SATA Info only
SATA Controller(s) Enabled
Disabled Enable/Disable Serial ATA.
SATA Mode Selection IDE Mode
AHCI Mode Select IDE/AHCI
SATA Test Mode Enabled
Disabled Test Mode enable/disable
SATA Controller Speed Gen1
Gen2 SATA speed support Gen1 or Gen2.
SATA Port Configuration Submenu
7.3.4.1. SATA > SATA Port Configuration
Feature Options Description
SATA Port Configuration Info only
Port X Disabled
Enabled Enable/Disable SATA port X.
HotPlug Enabled
Disabled Enable/Disable SATA port X hotplug.
7.3.5. USB
Feature Options Description
USB Info only
USB Module Version Info only
USB Devices Info only Drives, keyboards, mouse, hubs
Legacy USB Support Enabled
Disabled
Auto Enables legacy USB support.
Auto option disables legacy support if no USB devices are
connected.
Disable option will keep USB devices available only for EFI
applications and setup.
XHCI Hand-off Enabled
Disabled This is a workaround for OSes without XHCI hand-off support. The
XHCI ownership change should be claimed by the XHCI OS driver.
EHCI Hand-off Enabled
Disabled This is a workaround for OSes without EHCI hand-off support. The
EHCI ownership change should be claimed by the EHCI OS driver.
USB Mass Storage Driver Support Enabled
Disabled Enable/Disable USB mass storage driver support.
Chipset USB Configuration Submenu
USB hardware delays and time-outs: Info only
USB transfer time-out 1 sec
5 sec
10 sec
20 sec The time-out value for control, bulk, and interrupt transfers
Device reset time-out 10 sec
20 sec
30 sec
40 sec USB mass storage device Start Unit command time-out.