ADLINK ND-6018 - Manual (Page 62)

54 • Command Set
3.17 Enable/Disable channels for Multiplexing
@Description
Enable/Disable multiplexing simultaneously for individual channel.
@Syntax
$(Addr)5(ChannelVal)
$ Command leading code. (1-character)
(Addr) Address ID (2-character)
5 Enable/Disable channel. (1-character)
(ChannelVal) bit 3~0 of 1st character: control channel 7 - 4.
bit 3~0 of 2nd character: control channel 3 - 0.
bit value 0: Disable channel
bit value 1: Enable channel (2-character)
@Response
!(Addr)
or
?(Addr)>
! Command is valid.
? Command is invalid.
(Addr) Address ID.
@Example
User command: $06548
Response: !06
$ Command leading code.
06 Address ID.
5 Disable/Enable channel.
48 Channel Value is 0x48.
‘48’ is 01001000 that means enable channel 3 and
channel 6, the other channels are all disable.
(6013, 6017, 6018)