Dacor Preference PHW - Manual (Page 6)

4
PreParIng for InstallatIon
NOTE:
The mounting hardware
included with the hardware
packet is suitable for mounting
to brick and masonry only. If
mounting the range hood to
drywall,
Dacor strongly recommends
the using an anchoring system
designed for use with drywall.
In addition, Dacor strongly
recommends that you install
a reinforced mounting block
between the studs behind all
hood mounting locations.
location Planning
Carefully check the location where the hood is to be
installed. The hood should be placed for convenient
access. Make certain that electrical power can be provided
in the selected location.
Plan the installation so that all minimum dimensions are
met or exceeded (see page 3). Dimensions shown provide
minimum clearances, unless otherwise noted.
All contact surfaces between the hood and any cabinets or
walls must be solid and at right angles.
Install the range hood and cooking appliance(s) so that
they can be removed if service is required.
Make sure you have everything necessary for proper
installation before proceeding with the installation.
A
B
Verify the Package contents
Unpack the parts box and verify that all required
components have been provided. If any item is missing or
damaged, please contact the dealer immediately. Do not
install a damaged or incomplete appliance.
Blower assembly with filters
Chimney assembly (2 piece)
Chimney mounting bracket
Blower assembly mounting bracket
Tempered glass hood*
Mounting and assembly hardware
Mounting hardware template
Use and care manual
A
B
C
D
E
F
G
H
8” (203mm)
C
D
E
F
G
H
* The glass hood comes in different colors and sizes. See the
use and care manual maintenance section for part numbers.