Acrosser AR-B9612 User Manual
Page 37
4-6 AR-B9612 User’s Guide
4.2.3 Hard Disk Setup
The BIOS supported 48 types for user setting, The BIOS
supported
install up to two hard disks. The master and slave jumper
adjusting, please refer to the hard disk’s installation description
and the hard disk jumper setting.
CAUTION: AR-B9612 can not support the 32Bit Transfer, so
Acrosser recommends user configure the <32Bit>
field is always [Off], not setting [On].
You can select
This will enable auto detection of your IDE drives during bootup.
This will allow you to change your hard disk drives (with the
power off) and then power on without having to reconfigure your
hard drive type. If you use older hard disk drives which do
not support this feature, then you must configure the hard disk
drive in the standard method as described above by the
The user type referring to the hard disk type setting, it always
sets the
will find the hard disk size.
4.2.4 Virus Protection
This option protects the boot sector and partition table of your
hard disk against accidental modifications. Any attempt to
write to them will cause the system to halt and display a warning
message. If this occurs, you can either allow the operation to
continue or use a bootable virus-free floppy disk to reboot and
investigate your system. The default setting is Disabled. This
setting is recommended because conflicts with new operating
systems. Installation of new operating systems require that
you disable this to prevent write errors.