Acrosser AR-B9612 - Manual (Page 21)

3-2 AR-B9612 User’s Guide
3.2 SYSTEM SETTING
Jumper pins allow you to set specific system parameters. Set
them by changing the pin location of jumper blocks. (A
jumper block is a small plastic-encased conductor [shorting plug]
that slips over the pins.) To change a jumper setting, remove
the jumper from its current location with your fingers or small
needle-nosed pliers. Place the jumper over the two pins
designated for the desired setting. Press the jumper evenly
onto the pins. Be careful not to bend the pins.
We will show the locations of the AR-B9612 jumper pins, and
the factory-default setting. Note that the square pin of each
jumper block is pin 1.
CAUTION : Do not touch any electronic component unless you
are safely grounded. Wear a grounded wrist
strap or touch an exposed metal part of the system
unit chassis. A static discharge from your
fingers can permanently damage electronic
components.