Acrosser AR-B9612 - Manual (Page 19)

2-14 AR-B9612 User’s Guide
Software Programming
You can use the DOS and command to
format and copy files. Follow the following steps to format
and copy files to the FLASH disk.
Step 1: Turn on your computer, when the screen shows the
SSD BIOS menu, please hit the [F1] key during the
system boot-up, this enables you to enter the FLASH
setup program.
Step 2: Use , , , and
arrow keys to select the correct FLASH memory type
and how many memory chips are going to be used.
Step 3: Press the [F4] key to save the current settings.
Step 4: After the DOS is loaded, use the DOS [FORMAT]
command to format the FLASH disk
To format the disk and copy DOS system files to the
disk.
C:\>FORMAT [ROM disk letter] /S /U
To format the disk without copying DOS system files.
C:\>FORMAT [ROM disk letter] /U
Step 5: Copy your program or files to the FLASH disk by using
DOS [COPY] command.
CAUTION: It is not recommended that the user format the disk
and copy files to the FLASH disk very often.
Since the FLASH EPROM’s write cycle life time is
about 10,000 or 100,000 times, writing data to the
FLASH EPROM chips, especially the FLASH
EPROM chips, especially the FLASH EPROM chip
in the MEM1 socket.