Oéáåëí~ддбец=ньй=sáçéç=aêáîéê – 3DLABS Wildcat II 5110 User Manual

Page 37

Troubleshooting

3Dlabs Graphics Accelerator Card User's Guide

oÉáåëí~ддбеЦ=нЬЙ=sáÇÉç=aêáîÉê=

Note: You must have the correct driver for the Windows NT 4.0 or Windows 2000 operating system. If
you are unsure, refer to the

README

TXT

file located on the driver delivery media for this information.

Refer to the Microsoft Windows NT 4.0 or Windows 2000 documentation and online Help for more
information on installing drivers and software application programs.

If you are installing the Wildcat II 5110 driver, you must remove the current driver prior to installing the
update.

Removing the existing Wildcat II 5110 driver under Windows NT

1. Log on using an account that has administrative privileges.
2. From the operating system Start menu, go to Settings/Control Panel and double-click

Add/Remove Programs.

3. On the Add/Remove Programs Properties Install/Uninstall tab, highlight the Wildcat II

5110 Display Driver and click Add/Remove.

4. Click Yes when prompted to confirm the driver removal, and follow the prompts.

Reinstalling the video driver under Windows NT

1. Log on using an account that has administrative privileges.
2. Insert the delivery media into the appropriate device (for diskettes or CD).
3. From the operating system Start menu, go to Settings/Control Panel/Display and click the

Settings tab.

4. Click Display Type, then click Change.
5. In the Change Display dialog box, click Have Disk.
6. In the Install From Disk dialog box, type the path to the directory that contains the delivery

media.

7. In the Change Display dialog box, verify that the Wildcat II 5110 driver is highlighted,

then click OK.

8. Click Yes when asked if you want to install a third-party driver. The files are copied from

the delivery media.

9. After the driver files are copied, a message that the driver successfully installed displays.

Click OK.

10. Click Close to exit the Display Type dialog box.
11. Click Close to exit the Display Properties dialog box.
12. When told that the workstation must be restarted for the new settings to take effect, remove

the diskette from the workstation’s floppy disk drive, if applicable. Click Yes to restart the
workstation.

13. After the system restarts and you log in, a message displays stating that a new display

driver has been installed, and that you should use the Display option in the Control Panel to
select the preferred display resolution. Click OK.