3DLABS Wildcat II 5110 - Manual (Page 16)

Setup
3Dlabs Graphics Accelerator Card User's Guide 10
8. Place the card into the correct slots and seat firmly. See your system documentation for
instructions on securing the card to the chassis. Loose cards and connections can cause grounding
and operating problems.
9. Remove the anti-static wrist strap, if used, and replace the cover on your system.
10. Reconnect the power cord.
If you are upgrading the graphics card in your system
Note: These instructions may be different than how you normally upgrade your graphics card or other
devices, but have been found to be the best method of insuring a successful installation of your new
hardware and software.
1. Uninstall the drivers for your old graphics card. Refer to your old graphics card’s documentation
or Help files for instructions on removing or uninstalling the old graphics card’s driver software.
2. Remove the existing graphics card from your system. To install your Wildcat II 5110 Graphics
Accelerator Card, see the hardware installation instructions.
3. Install the Wildcat II 5110 Graphics Accelerator Card driver software; see Installing the Driver
Software later in this chapter.