3DLABS Wildcat II 5110 User Manual
Page 15
Setup
3Dlabs Graphics Accelerator Card User's Guide
9
5.
If necessary, remove the back panel covers from the slots into which you are installing your
Wildcat II 5110 Graphics Accelerator Card, using a Phillips-head screwdriver.
6.
If an anti-static wrist strap was included in your box, attach it to your wrist and attach the other
end to a bare metal (as opposed to painted or sticker covered) surface on your system’s chassis.
7.
Remove your Wildcat II 5110 Graphics Accelerator Card from its anti-static packaging. Write
down the serial number for product registration and future use. The serial number is located on a
board label and looks like this:
136001B123456 Made in XXX Week XXXX