Dodge 2009 Journey - Manual (Page 470)

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
4. Install the bulb and connector assembly into the fog
light housing and rotate the connector
1 ⁄
4
turn clockwise
to lock it in place.
5. Reinstall the front lower wheel well access panel and
fasteners.
Tail/Stop Light, Rear Turn Signal Light, Tail Light,
Backup Light
The taillights are a two-piece design. The tail/stop lights
and rear turn signal lights are located in the rear corner
body panels. The tail and backup lights are located in the
liftgate.
Changing the Tail/Stop Light or Rear Turn Signal
Light
1. Open the liftgate.
2. Remove the two fasteners from the inboard side of the
taillight housing.
3. Carefully insert a trim stick (plastic flat-blade tool)
between the body panel and the outboard side of the
taillight housing with one hand and grasp the flange on
the inboard side of the taillight housing with the other
hand. Use the trim stick and hand pressure together to
disengage the taillight housing from the vehicle.
468 MAINTAINING YOUR VEHICLE