Avanti DGR-210 - Manual (Page 9)

Anti-Tip Bracket Installation
To reduce the risk of tipping the appliance by abnormal usage or improper door loading,
appliance must be secured by properly installing the anti-tip device packed with the appliance. the
1
,
2 .
3.
4.
5.
Place the anti-tip bracket on the floor as shown in Figure 4. If there is no sidewall, the dimension
given as 1/8" will be the distance of right/left side of appliance to right/left side of anti-tip bracket.
Anti-tip bracket can be installed on either right or left side.
Mark the locations of 2 holes of anti-tip bracket on the floor.
Use a 3/8" masonry drill bit and insert plastic anchor.
Secure bracket to floor using screws supplied.
Slide appliance into position. {Figure 3)
Figure 5
> Spacers Installation :
In order to keep the range away from the back wall at a distance of 6”; install the spacers as seen in
Figure.5 before installation of the range. Screw the spacers to the end of the screws located on the
bottom rear, then install the range.
> Electrical Connection
• Electrical connection must be made in accordance with local codes or in absence of local codes,
with the National Electrical Code, ANSIINFPA No.70-Latest Edition.
• Connect the 2-prong supply cord to a 120-volt, 60 Hz, 2-prong wall receptacle.
• Electrical connection must not interfere with gas connection.
Warning
Improper use of the grounded plug can result in a risk of electrical shock. If the power cord is
damaged have it replaced by an authorized Avanti Products Service Center.
> Mobile Home Installation
The installation of this range must conform with the Manufactured Home construction and Safety
Standard, Title 24 CFR, Part 3280 {formerly the Federal Standard for Mobile Home Construction and
Safety, Title 24, HUD (Part 280)} or, when such standard is not applicable, the Standard for Manufactured
Home Installations, ANSI A 225.1 and Manufactured Home Installations, Sites, and Communities^
ANSI/NFPA 501 A, or with local codes.
When this range is installed in a mobile home, it must be secured to the floor during transit. Any method
of securing the range is adequate as long as it conforms to the standards listed above.
Copies of the standards may be obtained from;
National Fire Protection Association
Batterymarch Park
____
uuincy, M a 022B9
American Gas Association
1515 Wilson Blvd._______
Arlington, VA 22209