A warning, Before using your gas range, Installation requirements for your gas range – Avanti DGR-210 User Manual
Page 6: Material requirements, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
A
WARNING
HAVE THIS RANGE INSTALLED BY A QUALIFIED INSTALLER.
Improper
installation,
adjustment,
alteration,
services,
or
maintenance can cause injury or property damage. Consult a
qualified installer, service agency, or the gas supplier.
Before Using Your Gas Range
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the parts listed below;
Oven Rack
Backguard with two screws
Orifice Packet -
Anti-tip bracket
4 leveling legs
2 cooking grids
4 caps and 4 rings in the burner assembly
4 burner knobs
1 oven knob
1 Heat deflector (DGR-210 only)
Broiler Tray (DGR-210 only)
2' Spacers
Clean the interior surface with lukewarm water using a soft doth. (See “Cleaning” on
Page 14)
Have the installer show you the location of the ranges gas shut-off valve and how to
shut it off if necessary.
Have your range installed and properly grounded by a qualified installer in
accordance with the Installation Instructions.
Do not attempt to repair or replace any part of your range unless it is specifically
recommended in this manual.
Be sure your range is correctly adjusted by a qualified service technician or installer
for the type of gas (natural or LP) that is being used.
Installation Requirements for Your Gas Range
Material Requirements
•
Gas line shutoff valve
•
Vz NPT male pipe thread for connection to pressure regulator
•
L.P. Gas resistant pipe-joint compound
•
AGA or CGA design-certified flexible metal connector (4-5 feet) or rigid gas supply line as
______ needed_________________________________________________________________________
Insulated pad or %" plywood if range is installed over carpeting