Operating your gas range, Operation of surface burners – Avanti DGR-210 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR GAS RANGE
Before operating the unit, read this section thoroughly.
The first time the burners are used, a small amount of
smoke may be generated due to burning of grease on the
burners, especially on oven and broiler burners. This is not
dangerous. For that reason, the burners must be operated
without any cooking purpose for 10 minutes for the first
time. This range is equipped with an electric ignition
system to ignite the burners. Therefore, it must be
supplied with electricity. If any electric power failure
occurs, using a match can ignite the burners. A constant
supply of air is needed for combustion. Therefore, allow
sufficient ventilation into the room where the range is
placed.
> Manual Lighting Of The Oven Burner During Power Outage
You should place a lighted match next to the entrance of the burner hole. Depress the oven burner knob
and turn counter-clockwise. Keep the control knob depressed for 10 seconds after lighting. Check that
the burner Is lit (Figure 7). Use extreme caution when lighting burners in this manner.
Figure 7
>
Operation of Surface Burners
There are 3 different types of surface burners with different size and heat output on the
cook top.
A rapid burner (Front Right)
Two semi-rapid burners (Back)
A simmer burner (Front Left)
10