Water protection system, Electrical connection – AEG OKO FAVORIT 3130 User Manual

Page 38

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Water protection system

To protect your dishwasher from water damagé, it is equipped with a water pro
tection system.
Apart from an overflow protection, which prevents uncontrolied rising of water in
the appiiance, it also features an outiet protection {float switch in the floor tray).
This responds in the event of any untightness in the machine.

in aii cases of malfunction, the water suppiy is immediately interrupted and the

drain pump switched on. This prevents water from either flowing out or over
flowing. Any residual water in the appliance is automatically pumped away. Tine

pump also operates even if the machine is switched off and should not be dis

connected from the electricity suppiy.

A fault is recognised by the fact that a pump noise can be heard - even when the

machine is switched off.

□ If a fault occurs, first turn off the water tap. Then pull the plug out of the plug

socket. If there is a fixed connection, switch off or unscrew the fuse(s).

Electrical connection

According to the technical connection conditions of the electricity companies, a
fixed connection to the mains suppiy may only be made by an approved electri

cal installer.

Comply with the VDE specifications when connecting the machine and also where
necessary with the additional regulations of the local electricity companies. After
installation, live parts and insulated lines should not be accessible with-the test

finger to EN 60335/DIN VDE 0700.

Details of the electrical connection are given on the rating plate. This is located

on the RH inside edge of the door. If the machine is convertible, the changeover

diagram directions given on the mains junction box must also be observed.

During appliance connection, it is essential to ensure that the nominal voltage and
current type specified on the rating plate are the same as the mains voltage and
current type at the installation site. The necessary electrical fusing is also indi
cated on the rating plate.

to disconnect the dishwasher from the mains suppiy, pull cut the plug. Should

the appliance hav5 a fixed wiring connection with the mains supply, it musi be

disconnected by appropriate measures on the fixed wiring side (fUses, auto
matic cutout, spurious current protection switch, or the like which have a
contact opening width > 3 mm).