Autostart AS-2370 - Manual (Page 8)

To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.
Remote Trunk Release
If your system was installed with the remote trunk release option, you can open your trunk by
pressing the trunk button for 3 seconds.
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill
option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the crank position.
Safe Start
If this feature is enabled, the user must press the start / stop button 2 times within 3 seconds to
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
1. Press and release the start / stop button.
The parking lights will turn on.
2. Within 2 seconds of the parking lights turning on, press and release start / stop again (before
the parking lights turn off).
If Swap Start Mode is selected, to remote-start your vehicle press shift and then lock . The aux 2
output can be activated by pressing the start / stop button.
Installer-Programmable Valet Modes
Valet Mode Using the Valet Switch (if installed)
To put the system i n t o Valet Mode:
• Turn the ignition key to the ignition on ( run ) position.
• Within 3 sec., press the valet button, the parking lights will flash three times and the
L.E.D. will come on solid once the ignition key is removed.
To take the system out of Valet Mode:
• Turn the ignition key to the ignition on ( run ) position.
• Within 3 sec., press and release the valet button , the parking lights will flash twice
the L.E.D. will turn itself off.
Note : With the Valet mode with the Valet Switch activated, the remote starter will be disabled.
"Home ValetTM" Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system i n t o Home Valet Mode:
• Press the lock button.
• Within 3 seconds, press the start / stop and lock buttons simultaneously
until the Parking Lights go out.
To take the system out of Home Valet Mode:
• Turn the ignition key to the ignition on ( run ) position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
P. 8 User Guide
• Go on then off ; then
• Flash twice, pause; then
• Flash twice again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
Follow all steps of the Ready Mode routine to activate Turbo Mode:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press lock , unlock or start / stop on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. lock to lock the doors and shut down the engine after 60 sec.;
b. unlock to unlock the doors and shut down the engine after 60 sec.;
c. start / stop to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
D. trunk to set the vehicle into idle mode
Engine Run Time
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3,15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8,20, or 30 minutes (20 minutes default).
Constant While Pressed:
If enabled and if your vehicle is compatible, this option allows you to open or close your windows at
a distance, open or close the sunroof or even to open or close a sliding door:
• Pressing and holding the lock button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the lock button is held down (maximum of 15 seconds). This
constant pulse can be configured to activate certain functionalities such as rolling up the
windows - Please refer to your installer to see if your vehicle is compatible with this
option.
• Pressing and holding the unlock button for more than 3 seconds will unlock all doors and will
send a constant pulse as long as the unlock button is held down (maximum of 15 seconds).
This constant pulse can be configured to activate certain functionalities such as rolling down the
windows - Please refer to your installer to see if your vehicle is compatible with this
option.
Horn Chirp Timing
The pulse duration can be configured by your installer (from 5 ms to 200 ms).
Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, press and hold the
lock and unlock buttons for 3 seconds:
• Flashing LED on : the L.E.D. will flash at all times (either under active arming or under passive
arming) to indicate that the starter kill is active.
• Active Arming: the LED will flash normally.
User Guide P. 9