Autostart AS-2370 - Manual (Page 7)

• Passive Arming: the LED will not flash during the countdown preceding the activation of
the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate.
• In Valet Mode: the LED will remain lit without flashing.
• Flashing LED off : the LED will not flash even when the module is armed (either under active or
passive arming). Nevertheless, if the module enters valet mode, the LED will still remain lit
without flashing as long as the ignition is off.
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same Remote Car Starter
model, to control both systems with a single remote control.
To control the second vehicle:
Press TRUNK + lock buttons simultaneously:............................ lock
Press TRUNK + unlock simultaneously:..................................... unlock
Press TRUNK + start / stop simultaneously:.................................. start
Press TRUNK + start / stop simultaneously:.................................. stop
Press shift > shift > trunk :.............................................................TRUNK
or
Press SHIFT > SHIFT > lock :........................................................... lock
Press SHIFT > SHIFT > unlock :...................................................... unlock
Press SHIFT > SHIFT > START/STOP:............................................START
Press SHIFT > SHIFT > START/STOP:............................................STOP
Press SHIFT > SHIFT > TRUNK:...................................................... TRUNK
Note: If the multi-level features have been modified from their default state by your installer,
the
shift button may have to be pressed once, twice or three times, according to the option
you chose.
[Multi-Level Features {defaultstate)
The multi-level features allow you to access different features of your vehicle or of a second car by
pressing the shift button once, twice or three times. By default, the multi-level features are
programmed as follows:
Basic features (press the shift button 1X)
SHIFT > LOCK:...
SHIFT > TRUNK:...
SHIFT > START/STOP..
Multi-car operation ( press the shift button 2X)
SHIFT > SHIFT > LOCK:........................
SHIFT > SHIFT > UNLOCK:..................
SHIFT > SHIFT > START/STOP:...........
SHIFT > SHIFT > TRUNK:.....................
aux 2
status request
.cold weather
,2 nd car lock
,2 nd car unlock
2 nd car start/stop
2 nd car trunk
Customized features (press the
shift button 3X)
(May not be applicable for certain vehicles)
Your Installer can add customized features such as turning on the radio, opening sliding doors, etc.
SHIFT >
SHIFT > SHIFT > ......... ........... LOCK: customized feature 1
SHIFT > SHIFT > SHIFT > ......... ........... UNLOCK: customized feature 2
SHIFT > SHIFT > SHIFT > ......... ........... TRUNK: customized feature 3
SHIFT > SHIFT > SHIFT > ......... ........... START/STOP: customized feature 4
P. 10 User Guide
Feature Confirmation Chart
Feature LED #1 LED #2 LED#3 LED #4 Beep(s)
Lock 3 flashes X X X 1
Unlock X 3 flashes X X 2
Trunk X X 3 flashes X 1
LED ON/OFF 3 flashes 3 flashes X X 1
Start X X X 3 flashes 1
Running X X X 3 flashes 3
Stop X X X 3 flashes 2
Entering Cold
Weather Mode
X X X 3 flashes 2
Exiting Cold
Weather Mode
X X X 3 flashes 1
Home Valet 3 flashes X X 3 flashes 2
Valet Mode 3 flashes X X 3 flashes 1
Exit ValetMode X 3 flashes X 3 flashes 1
Fail Start Attempt X X X 4 flashes 4
Advanced Features: Installation-programmable Options
The remote car starter was designed with flexibility and OEM integration in mind. With its program­
mable options, this unit can single-handedly control nearly any electrical system in your vehicle.
Caution: The programming of your system should be left to a professional. Changing any
one of the settings may affect the operation of your Remote Car Starter.
Remote Door Locks
If your Remote Car Starter was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry. See section Arming the Starter Kill, earlier in this Guide, for
further instructions on remote door locking and unlocking.
Priority Door Access
If the Remote Door Locks option is installed on your vehicle, this safety feature allows you unlock
solely the driver's door with a single press of the
unlock button on the transmitter; upon a second
press of the unlock button, all the other doors will unlock.
Ignition-controlled Door Locks
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically be locked as soon as the ignition key is
turned to the
ignition on ( run ) position while the brakes are pressed. When the key is turned to the
off position, the doors will automatically be unlocked.
Ignition Re-lock
On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the
ignition key is in the
ignition on ( run ) position, should any door be unlocked and opened, all doors
will be relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory
security system. The Secure Lock feature may be required on certain vehicle models with factory
security systems that automatically unlock the doors when the security system is disarmed.
User Guide P. 7