ADT Security Services Commercial Fire & Burglary Alarm System FOCUS 200 PLUS - Manual (Page 73)

System Test (cont’d)
Protection Groups
Use this test to determine if the selected Burglary group is ready to turn on.
1. Using the operating panel’s numeric keypad, enter a valid ID code to
display Action Menu 1.
2. Press More to display Action Menu 2.
3. Press Test to display Test Menu 1.
4. Press Burglary groups to display the "Burglary Group Descriptions."
5. Press Previous or Next to display the “Group description” to be tested.
6. Press Group description to test that specific group and to display the
test results.
7. Press Quit to display Action Menu 2.
8. To test additional groups, repeat steps 3 through 7.
Testing Holdup, Fire, and Supervisory Devices
Caution: Use care when conducting this test. All holdup, fire, and
supervisory functions are disabled during this test mode. In the event of a
security breach or fire, no signals will be sent to the monitoring center.
1. Using the operating panel’s numeric keypad, enter a valid ID code that
has been assigned the privilege level of "Can change perm sched" or "Can
bypass FA/HU/SPV."
2. Press More to display Action Menu 2.
3. Press Test to display Test Menu 1.
4. Press Sensor points to display types of devices to be tested.
5. Press Holdup, Fire, or Supervisory to display the test instructions.
6. Press More twice to scroll through burglar device test instructions. Press
“?”. Press More twice to scroll through fire, holdup, and supervisory test
instruction. Press Quit. Press More twice for the remainder of the test
instructions.
73