ADT Security Services Commercial Fire & Burglary Alarm System FOCUS 200 PLUS - Manual (Page 66)

System Operation (cont’d)
System Test (continued)
Output Trouble OUTPUT TBL
Output Trouble Restore OUTPUT RST
Point Trouble POINT TBL
Point Alarm - general alarm POINT ALM
Point Alarm Restore - general alarm restore POINT RST
Untyped Diagnostics UAWAN
Burglary Alarm Weak Battery B WEAK BAT
Fire Alarm Weak Battery F WEAK BAT
Holdup Alarm Weak Battery H WEAK BAT
Supervisory Alarm Weak Battery S WEAK BAT
Untyped Alarm Weak Battery U WEAK BAT
Weak Battery Restore BAT RESTOR
Dialer Test
Dialer Test Report DLR TEST
Dialer Test Report with System Trouble Present TBL TEST
Bypassing/Unbypassing Burglary Protection
Bypassing a point or part of the burglary protection will cause the system to
ignore that point or portion of protection until it is unbypassed (restored to
normal operation) or the system is turned off.
Bypassing may be required to ignore a malfunctioning device or to allow
access to permanently secured areas. Only those users assigned the privilege
level of "Can Bypass BA" may bypass and unbypass protection.
Bypassing Protection Points
Note: A bypassed point cannot detect intrusion or an alarm condition.
Before resorting to bypassing a point, attempt to repair or correct the
problem.
1. Using the operating panel’s numeric keypad, enter a valid ID code that
has been assigned the privilege level of "Can bypass BA."
66