AEG 155 D User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Drill four holes in the base of the wall unit using the template

Wall unit

supplied.

mounting

Mount the hood unit on the base of the wall unit using four

4,2

35 mm screws.

-Fig.4

If using an interchangeable model, fit the plastic caps supplied in

any unused mounting holes. —

Fig. 5

Position the template on the wall.
Drill four 8 mm 0 holes in the wall, 2 in points

and 2 in points I.

Fit the four 8 mm screw anchor plugs in the wall.

Screw two 5 X 45 mm screws in points

but do not tighten

them fully home.
Adjust the unit so that it is positioned at a right angle to the wall

by turning the two support screws G.

Now hang the hood on the wall (holes

H).

Tighten the first two

screws and, for safety’s sake, screw the other two 5 x 45 mm
screws (holes I) Into the holes in the hood. —

Fig. 6

Wall

mounting