Black & Decker SR650 - Manual (Page 14)

4. The collar behveen cutters method, as shown in Figure 29, has both
the odvantages of the first two methods and is frequently used
where both edges of the work are to be shaped.
Starting Pin
1. Your machine is supplied with a starting pin which is used as a
support when starting the cut. The starting pin is placed into the
threaded hole in the table.
2. The work should be placed in the first position using the starting pin
as a support, as shown in Figure 30. Then swing the work into the
cutter as shown in the second position. The work will now be
supported by the collar and starting pin as shown in Figure 30.
3. After the cut has been started, the work is swung free of the starting
pin and rides only against the collar as shown in the third position
Figure 31.
ALWAYS FEED AGAINST THE ROTATION OF THE CUTTER.
IMPORTANT; If the work would be advanced to the cutter without the
side support of the starting pin, it would invariably be kicked back.
Accessories
Recommended accessories for use with your tool are available at
extra cosf from your local dealer or authorized service center.
CAUTION: The use of any accessory not recommended for use with
this tool could be hazardous. Use only cutters that are rated above
10,000 RPM and equal to or less than 2-1/2" (63.5mm) diameter.
If you need assistance in locating any accessory, please contact:
Black & Decker (U.S.) Inc.
Consumer Service Dept.
626 Hanover Pike, P.O. Box 618
Hampstead, MD 21074-0618
Phone: 1-800-762-6672
To purchase Black & Decker bench tool accessories, which are not
available at your local retailer, please call Black & Decker Teleservice
at 1-800-258-6003.
Important
To assure product SAFETY and REUABIUTY, repairs, maintenance and
adjustment (including brush inspection and replacement) should be
performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Two-Year Home Use Warranty
Black & Decker (U.S.) Inc. warrants this product for two years against
any defects thot are due to faulty material or workmanship. Please
return the complete unit, transportation prepaid, to the seller (if a
participating retailer) for free replacement (proof of purchase may be
required). This unit may also be returned to a Black & Decker service
center or authorized service station, listed under "Tools-Electric" in the
yellow pages for free replacement or repair at our option. This
warranty does not apply to accessories. This warranty gives you
specific legal rights and you may have other rights which vary from
state to state. Should you have any questions, contact your nearest
Block & Decker service center manager.
This product is not intended for commercial use.
Every Black & Decker tool is of the highest quality. If you wish to
contact us regarding this product, please call toll free between
8:00 a.m. and 8:00 p.m. ET, seven days a week.
1 - 800 - 762-6672
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Ro.
Tovrson, MD 21286 U.S.A.
S m 'Tool»-EI*ctrlc'
- Yellow Peges -
Tor Service 1 Selee
12