Avanti DG20CW - Manual (Page 12)

Manual Lighting Of The Oven Burner During Power Outage
You should place a lighted match next to the entrance of the burner hole. Depress the oven
burner knob and turn counter-clockwise. Keep the control knob depressed for 10 seconds after
lighting. Check that the burner is lit (Figure 5). Use extreme caution when lighting burners
In this manner.
Figure 5
Figure 6
> Operation of Surface Burners
There are 3 different types of surface burners with different size and heat output on the
cook top.
A rapid burner (Front Right)
Two semi-rapid burners (Back)
A simmer burner (Front Left)
A WARNINGS
DO NOT ATTEMPT TO OPERATE ANY SURFACE BURNER WITHOUT
INSTALLING IT. OTHERWISE, THERE IS A RISK OF EXPLOSION.
First, the surface burners must be installed correctly, as seen in Figure 5.
The ring and its cap must be in its place. The burners should be level with the surface of
the main top.
The cookware supports must be in their places on the cook top. These plastic rings are
already in place and are used to prevent rocking as shown in Figure 6. Use stable
cookware with a flat bottom and always place the utensils on the cookware supports before
lighting the burner.
The surface burners are controlled by knobs located on control panel at front side of the
appliance, as seen in Figure 7,
There is a symbol over the knob on the control panel to identify which knob controls which
burner. Also, there is a symbol indicator on the knobs, to aid in setting the burner to the
desired temperature.
in