À warning, Leveiinq of range, Anti-tip bracket installation – Avanti DG20CW User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION OF YOUR GAS RANGE
À WARNING?
HAVE THIS RANGE INSTALLED BY A QUALIFIED INSTALLER,
improper
installation,
adjustment,
alteration,
services,
or
maintenance can cause injury or property damage. Consult a
qualified installer, service agency or the gas supplier.
^ Leveiinq of Range
The range must be level to obtain proper cooking results.
The screwed leveling legs located on the comer brackets at the
bottom of range should be adjusted by turning them clockwise to
make the range higher or counter-clockwise to lower the range
until the range is level {See Figure 1). Use a level on the
cookware supports to check the leveling of the range.
> Anti-Tip Bracket Installation
To reduce the risk of tipping the appliance by abnormal usage or improper door loading, the
appliance must be secured by properly installing the anti-tip device packed with the
appliance.
^
.
1. Place the anti-tip bracket on the floor as shown in Figure 3. If there is no sidewall, the
dimension given as 1/8" will be the distance of right/left side of appliance to right/left side
of anti-tip bracket. Anti-tip bracket can be installed on either right or left side.
2. Mark the locations of 2 holes of anti-tip bracket on the floor.
3. Use a 5/16" masonry drill bit and insert plastic anchor.
4. Secure bracket to floor using screws supplied.
5. Slide appliance into position. (Figure 2)
.
Ficure 2