Electrical connection, Mobile home installation, Operating your gas range – Avanti DG20CW User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
> Electrical Connection
•
Electrical connection must be made in accordance with local codes or in absence of
local codes, with the National Electrical Code, ANSlINFPA No.70-Latest Edition.
•
Connect the 2-prong supply cord to a 120-volt. 60 Hz, 2-prong wall receptacle.
•
Electrical connection must not interfere with gas connection.
Warning
Improper use of the grounded plug can result in a risk of electrical shock. If the power cord is
damaged have it replaced by an authorized Avanti Products Service Center.
Mobile Home Installation
The installation of this range must conform with the Manufactured Home constriction and Safety
Standard, Trtle 24 CFR, Part 3280 {formerly the Federal Standard for Mobile Home Construction and
Safety, Title 24. HUD {Part 280)} or, when such standard is not applicable, the Standard for Manufactured
Home installations. ANSI A 225.1 and Manufactured Home Installations. Sites, and Communities
ANSI/NFPA 501 A, or with local codes.
When this range is installed in a mobile home, it must be secured to the floor during transit. Any method
of securing the range is adequate as long as it conforms to the standards listed above.
Copies of the standards may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy. MA 02269
Amerid&n Gas Association
1515 Wilson Blvd.
Ariington, VA 22209
OPERATING YOUR GAS RANGE
Before operating the unit, read this section thoroughly.
The first time the burners are used, a small amount of
smoke may be generated due to burning of grease on the
burners, especially on oven and broiler burners. This is not
dangerous. For that reason, the burners must be operated
without any cooking purpose for 10 minutes for the first
time. This range is equipped with an electric ignition
system to ignite the burners. Therefore, it must be
supplied with electricity, if any electric power failure
occurs, using a match can ignite the burners. A constant
supply of air is needed for combustion. Therefore, allow
sufficient ventilation into the room where the range is
placed.