American Standard 212-1090 User Manual
Dumount kitchen sink, Enameled cast iron
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dumount Kitchen Sink
ENAMELED CAST IRON
Dumount Kitchen Sink (212-1089). Faucet, sprayer, and
drains shown not included.
■ 33" (838 mm) Length, 22" (559 mm) Width,
8" (203 mm) Bowl Depths - 115 lbs., Cubes 5.83
■ Self-Rimming, Double-Bowl Sink
■ Two Spacious 13-7/8" x 16-1/2" x 8" Bowls
■ Offset Drains Provide More Flat Space in Bowls
■ Available in Three-, Four-, or Five-Hole Models
■ Optional Cutting Board, Wire Racks and Wire
Basket Available
■ Available in White, Platinum, Onyx, Almond, and Biscuit
□
212-1088
® Enameled Cast Iron, Self-Rimming,
Double-Bowl Kitchen Sink with Three
Faucet Holes
□
212-1089
« Enameled Cast Iron, Self-Rimming,
Double-Bowl Kitchen Sink with Four
Faucet Holes
□ 212-1090
Enameled Cast Iron, Self-Rimming,
Double-Bowl Kitchen Sink with Five
Faucet Holes
Notes:
Strainer Outlets 3-1/2"
Counter Cut Out - 31" x 20" with 1" radius
corners
Eljer assumes no responsibility or liability for local or
state regulations which deviate from national standards.
It shall be the responsibility of the installer to comply
with local codes and standards prior to installation of
any Eljer product.
282-1089 Hardwood Cutting
Board - Fits Left Bowl
805-3161 White Plastic-Coated
Wire Rack - Fits Right Bowl
805-3160 (not shown) White
Plastic-Coated Wire Rack - Fits
Left Bowl
Q CSA Certified
805-2165 White Plastic-Coated
Wire Basket - Fits Either Right
or Left Bowl
Optional Accessories
□ 805-3160 White Plastic Coated Wire Rack
Fits Left Bowl
□ 805-3161 White Plastic Coated Wire Rack
Fits Right Bowl
□ 805-2165 White Plastic Coated Wire Basket
Fits Either Bowls
□ 803-0580 Polished Chrome Kitchen Sink Strainer with
Removable Crumb Cup, For 3-1/2" Outlet
□ 803-0586 Polished Brass Kitchen Sink Strainer with
Removable Crumb Cup, For 3-1/2" Outlet
□ 282-1089 Hardwood Cutting Board, Fits Left Bowl
FAUCETS ARE NOT INCLUDED. ALL FIXTURE DIMENSIONS ARE NOMINAL AND
MAY VARY WITHIN THE RANGE OF TOLERANCES ESTABLISHED BY ASME/ANSI
STANDARDS, A112.19.1M. ALL MEASUREMENTS SHOWN ARE SUBJECT TO
CHANGE OR CANCELLATION.
Eljer, Inc. 2/07
Sinks 4.1