Bolens 126-216-000 - Manual (Page 13)

CARBURETOR ADJUSTMENTS
FIGURE 23.
CUTTING HEIGHT ADJUSTMENT
The height adjustment handle is iocated on the left side
of the deck. The handle may be placed in one of nine
cutting height positions. Push the handle to the left and
then either forward to lower the cutting height or
backward to raise the cutting height. See figure 24.
For rough or uneven iawns, move the height adjustment
handle to a position which will give a higher cutting
height.
THROTTLE
The throttle control wire assembly can be adjusted if
necessary. Refer to steps 8 thru 12 of assembly in­
structions.
A
t- warning (
If any adjustments are made to the
engine while the engine is running
(e.g. carburetor), keep clear of all
moving parts. Be careful of heated
surfaces and muffler.
Minor carburetor adjustment may be required to com­
pensate for differences in fuel, temperature, altitude
and load.
Refer to the separate engine manual packed with your
mower for carburetor adjustment information.
LUBRICATION
Ar
WARNING
Always stop engine and disconnect
spark plug wire before cleaning,
lubricating or doing any kind of
work on lawn mower.
Blade Control—Lubricate the pivot points on the blade
control handle and the brake cable at least once a
season with light oil. See figure 25. The blade control
must operate freely in both directions.
FIGURE 25.
Discharge Chute Door Mechanism—The torsion
spring and pivot point should be lubricated periodical­
ly with light oil to prevent any rust or binding. Door must
work freely.
Wheels—Mower may be provided with ball bearing
wheels. Lubricate at least once a season with light oil.
Also, if the wheels are removed for any reason,
lubricate the surface of the axle bolt and the inner sur­
face of the wheel with light oil. A 4 oz. plastic bottle
of light oil lubricant is available. Order part number
737-0170. Engine oil may also be used.
13