Agri-Fab Utility Cart 45-01001 - Manual (Page 7)

19. Assemble wheels as described in step 19,
using flat washers and cotter pins. See figure
13.
¿id. Turn cart assembly over to rest on wheels. This
completes the cart assembly. Be sure to read
safety rules and operating instructions before
using your new utility cart.
GENERAL SAFETY
PRECAUTIONS
Preventing accidents is the responsibility of every
equipment operator. The following general safety
precautions must be fully understood and followed
by every operator.
1. Do not at anytime carry passengers in this cart.
It is designed for carrying materials only and not
intended to carry passsengers.
2. Do not tow this utility cart on a public
thoroughfare at any time. The operator is risk­
ing injury from passing vehicles. Most local
ordinances prohibit operating a cart and trac­
tor such as this on a public thoroughfare.
3. When towing cart do not drive too close to a
creek or ditch and be alert for holes and other
hazards. The above could cause you to lose con­
trol of the cart and tractor.
4. Be careful on any grade (hill) and stay off of
steep grades.
5. Maximum towing speed - 10 M.P.H.
NOTE
Weighs limit-See specifications for
each model. One cubic foot of dirt
weighs approximately 150 lbs.
Do Not exceed cart weight capacity
of 650 lbs.
OPERATION
To dump material from the trailer box, remove the
tailgate by lifting it straight up and out from between
the guides. Release the spring latch by pulling the
latch handle forward, away from the trailer box.
dk
CAUTION
To avoid possible injury, be sure that
no one is near the trailer before releas­
ing latch.
A rope may be attached to the spring latch handle
for easy release by the operator while on the tractor
seat. The trailer box will tilt backward to empty its
contents. After unloading, pull the front of the box
down toward the trailer tongue until the latch snaps
in place. Replace tailgate if desired.
NOTE
For best handling, do not load trailer
too heavily behind center of axle.
MAINTENANCE
At the beginning of each season, lubricate the latch,
latch pivot bolt, and the axle where the hitch tongue
pivots, with a light machine oil.
1. Grease or oil wheel bearings occasionally. Use
automotive wheel bearing type grease or 20
weight oil.
2. Recommended tire pressure is 12-14 Lbs.