Cl technical details – Beko BD-610 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

- Check that the line cord is correctly
fitted and undamaged.
The CHARGE light on the base unit does
not come on.
- Check the handset is properly
stationed.
- Check the connections between the
base unit and mains power socket.
- Clean the batteries charging contacts
with a dry cloth.
When
I
press the CALL button, I hear a
loud noise.
- The strange noise is caused by
interference. Disconnect the mains
power lead from the back of the base
unit, and then wait for 30 seconds before
reconnecting it.
There is 'beep' sound while I am on a
call.
- You may be going out of range of the
base unit. Move closer, or your call may
be cut off.
- Check the Batteries Level symbol on
the display. If it is low, recharge the
batteries.
The Caller Display feature isn't working.
- You need to subscribe to the Caller
Display feature from your service
provider.
- The caller may have withheld their
Cl Technical Details
number, or they may be calling from a
network that does not transmit the Caller
ID {for example. It may be an international
call).
The handset’s batteries are running low
within an hour or two.
- Before you used the handset for the
first time, you should have left it on the
base unit for up to 15 hours to charge
the batteries ful^.
- If base station is not connected to an
ADSL modem with internet connection
, handset displays “connecting Skype”
and the batteries are discharged in a
few hours. To avoid this, connect base
to an ADSL modem.
- You may need to replace the batteries.
I cannot transfer a call.
- Make sure the other handset is within
range of the base unit, and is not busy
on a call.
- Make sure you are keying In the correct
number for the other handset.
No display on LCD screen.
- Make sure the batteries have power.
I cannot register handset to base
- Make sure the number of handset
registered to base is less than 4.
- Check that the base unit is not near
other electrical equipment, such as TV
or computer
m
Full DECT GAP Compatible system
Standard
Frequency range
Channel bandwidth
Modulation
Operating range
Operating time
Digital Enhanced Cordless
Telecommunications(DECT)
1.8 GHz 2.4 GHz
1.728 MHz
GFSK
Up to 300 m outdoors;
Up to 50 m indoors
Standby time: 120 hours
Talking time: 8 hours
23