Beko BD-610 - Manual (Page 21)

Left key to setect your preferred number
to set call barring (up to 5 numbers);
7. Use the keypad to key in the number,
press Left key to confirm;
To Set LCR (Least Cost Route)
With the LCR function, the phone will
automatical^ replace a bng number with
a comparative short number, to simplify
the process of dialing a long number.
For example, if the user program to
replace ”00“ with “17909“, then when
he dials “006567417211", then the
phone will automatically replace the
number to be dialed out as
“179096567417211“.
1. Press Scrolling button Left key to
select LCR under Base Settings mode;
2. Use the keypad to key the PIN
(Default:0000), press Left key to confirm;
3. Use the keypad to key in the SHORT
ED Resetting The System
number that you want to replace the
long number, press Left key to confirm;
4. Use the keypad to key in the LONG
number, press Left key to confirm.
To Change PIN
1. Press Scrolling button Left key to
select PIN under Base Settings mode;
2. Use the keypad to key in the original
PIN (0000), press Left key to oonfimn;
3. Use the keypad to key in the new PIN
you want to set, press Left key to
confirm.
Default Settings
1. Press Scrolling button Left key to
select Default unrder Base Settings mode;
2. Use the keypad to key in the current
PIN, press Left key to confirm, then all
teatures vr/ill return to their default
settings.
If you have set a PIN and forgotten it,
you need to reset the system. The PIN
will be reset to 0000. If you reset the
system, you will lose all stored
information (including numbers in
memory) and all features will return to
their default settings. You need to register
the handset to the base unit again.
While you are resetting the system, you
should disconnect the telephone line
cord from the back of the base unit, so
you won't be interrupted by incoming
calls. To reset the system without the
PIN;
1. Disconnect the power lead from the
back of the base unit
2. Press and hold the HANDSET
LOCATOR button in the base unit, at
the same time connect the power lead
into the back of base unit. Release the
LOCATOR button after you hear “beep"
sound for five times. The IN USE light
on base unit lights during this whole
process.
3. After 2~3 seconds, you can hear
“beep" sound for two times again and
the IN USE light goes off;
4. Disconnect the power lead from base.
Reconnect and you will hear a
confirmation tone from the base unit.
Contacts
Your list of contacts contains all Skype
users as well as all landline phone users
that you have added. There is a limit to
the number of entries you can make.
but your contact list can nevertheless
hold hundreds of contacts.
To access landline contacts, you have
to sign in to Skype.
19