Avanti DER24CSS - Manual (Page 18)

Lift-Off Oven Door
The oven door, glass or
enamelled sheet can be easily
removed for oven cleaning.
To remove it:
1- Open the door fully.
2- There is a small ring on
each hinge (See Figure
15). Pull the ring over the
claw-like hook, which is
part of the hinge
mechanism. Do not forget
to do this on both hinges
before the next step.
3- Raise the door slightly and
pull it straight out and
away from the oven. The
door will come completely
off.
To replace it:
1
-
2
-
3-
4-
Position the hinges in the hinge slots on
oven frame.
Hold the door horizontal and place both
small forms on oven frame.
Slip the rings off the claw-like hooks.
Close the door and make sure that it sits in
place fully, if not, repeat all above steps.
Lift-off the Drawer (available on some
models)
For cleaning, you can remove the drawer by
pulling it out until the stop point and lifting it up
(See Figure 17). Never store any flammable
material in the drawer.
Control Panel and Knobs
Clean up any spills or spatters with a damp
cloth. Remove heavier soil with warm, soapy
water. Clean the control panel with a mild
liquid dish detergent and a soft cloth. Rub
control panel lightly.
Oven Vent
The oven is vented through an opening at the
rear of the cooktop (See Figure 14). Never
cover the opening with aluminium foil or any
other material. This would prevent the oven
vent from working properly.
15 i«Mi i;wR4