Avanti DER24CSS User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Levelling of Range
The range must be level to obtain proper operating. The
screw type leveling legs located on the corners at bottom of
range should be adjusted by turning them clockwise to make
the range higher or counter-clockwise to lowec the range until
the range is level (See Figure 3). Use a level on surface units
to check the levelling of the range.
Anti-Tip Bracket instaiiation
To reduce the risk of tipping the appliance by abnormal usage or improper door loading, the
appliance must be secured by properly installing the anti-tip device packed with the appliance.
1 - Place the anti-tip bracket on the
floor as shown in Figure 4. Anti-
tip bracket can be installed on
either right or left side.
2- Mark the locations of 2 holes of
anti-tip bracket on the floor.
3- Use a 5/16" masonry drill bit and
insert plastic anchor.
4- Secure bracket to floor using
screws supplied.
5- Slide appliance into position
(See Figure 5).
NOTE; IF RANGE IS RELOCATED,
THE BRACKET MUST BE REMOVED
AND INSTALLED IN NEW LOCATION.
install the anti-tip bracket either left or right side.
‘The contour line of front pane! of appliance
Figure 4
10
IfxM 1