Figure 2 – Avanti DER24CSS User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Eiecthca! Connection
3-Wire Power Cord instaliation
See Figure 1.
1
-
2
-
3-
4-
5-
6
-
7-
8
-
Remove the back panel.
Assemble the strain relief in
the hole on bracket.
Insert the power cord through
the strain relief and tighten.
Allow enough slack to easily
attach the cord terminals to the
terminal block.
Remove the 3 wire terminal
nuts and washers from the
terminal block.
Plug the terminal holes of
power cord. The neutral or
ground wire of the power cord
must be connected to the
neutral terminal located in the
center of terminal block. The
power leads must be connected to the outside terminals
Plug washers and tighten nuts securely.
Assemble the back panel.
4-Wire Power Cord Instatlation
See Figure 2.
1
-
2
-
3-
4-
5-
6-
7-
Remove the back panel.
Assemble the strain relief in
the hole on bracket.
Insert the power cord through
the strain relief and tighten.
Allow enough slack to easily
attach the cord terminals to the
terminal block.
Remove the 3 wire terminal
nuts and washers from the
terminal block.
Remove the ground strap from
the
frame
of
range
and
terminal by removing its screw
and cutting it as shown in
figure 2.
Cut Ground Strap
Terminal Block
Neutral Wire
Power Wires
Bracket
Grounding Screw
Figure 2
Grounding Wire
Power Cord
Plug the terminal holes of power cord. The neutral wire of the power cord must be
connected to the neutral terminal located in the center of terminal block. The ground wire of
the power cord must be attached to the frame of range buy using the green coloured
grounding screw. The power leads must be connected to the outside terminals.
8- Plug washers and tighten nuts securely.
9- Assemble the back panel.