Section 4: unpacking, To remove unit from crate, Section 5; assembly instructions – Bolens LT-185 User Manual
Page 7: Tools required for assembly, Battery information, Warning, Danger
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 4: UNPACKING
TO REMOVE UNIT FROM CRATE
1. Remove all screws from the top of the crate
using a 1/4" hex head socket or a flat blade
screwdriver.
2. To remove ends, grasp top board on the end,
and pull towards you in a downward motion.
(A hammer may be helpful).
3. Set panel aside to avoid tire punctures.
4. Repeat procedure for each side of the crate.
5. Remove and discard plastic bag which covers
unit.
6. Loose parts (may include the owner’s guide,
steering wheel, optional oil drain hose, battery
fluid, chute deflector, etc.) are in a box wrapped
in plastic. Carefully cut and remove the plastic
wrap. Remove the loose parts.
7.
Make certain parking brake and hydrostatic
transmission relief valve are released and unit is
in neutral. See the controls section of this
manual for the location of the parking brake
release and the hydrostatic relief valve. Raise
the deck and push the unit off the skid.
SECTION 5; ASSEMBLY INSTRUCTIONS
IMPORTANT; After assembly, service engine
with gasoline, and check oil level as instructed
in the separate engine manual packed with your
unit._____________________________________
NOTE:
Reference to right or left hand side of
the unit is observed from the driver’s seat, facing
forward.
TOOLS REQUIRED FOR ASSEMBLY
(1) 1/4" socket wrench or flat blade screwdriver
(1) 1/2" wrench or socket wrench
(1) 9/16" wrench or socket wrench
(2) 7/16" wrenches or socket wrenches
BATTERY INFORMATION
A
WARNING
A.
B.
C.
D.
Battery acid must be handled with great care as
contact with it can burn and blister the skin. It is
also advisable to wear protective clothing (gog
gles, rubber gloves and apron) when working
with it.
Should battery acid accidentally splatter into the
eyes or onto the face, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical atten
tion.
If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of ammonia/
water or baking soda/water.
Since battery acid is corrosive, do not pour it into
any sink or drain. Before discarding empty elec
trolyte containers, rinse them with a neutralizing
solution.
E. NEVER connect or disconnect charger clips to
battery while charger is turned on as it can cause
sparks.
F.
Keep all lighted materials (cigarettes, matches,
lighters) away from the battery as the hydrogen
gas generated during charging can be combusti
ble.
G. As a further precaution, only charge the battery
in a well-ventilated area.
*Always shield eyes, protect skin and clothing
when working near batteries.
A
DANGER
Battery contains sulfuric acid. Refer to warning
at right. Antidote: EXTERNAL—Flush with water.
INTERNAL—Drink large quantities of water or milk.
Follow with milk of magnesia, beaten eggs or
vegetable oil. Call physician immediately. EYES:
Flush with cool water for at least 15 minutes, then
get prompt medical attention.
Since batteries produce explosive gases, keep
all
lighted
materials
(cigarettes,
lighters,
matches, etc.) away. Be sure to charge battery
only in well-ventilated areas. Make certain venting
path of battery drain tube (if equipped) is always
open.
KEEP BATTERIES
OUT OF THE REACH OF CHILDREN!