Beko BK 6340 Y - Manual (Page 13)

€ Г^ C
f^i—5
3
1 Hose nozzle-LPG
2 Hose nozzle-NG
3 Safety hose
4 0-ring (seal)
5 Clamp
Leakage control at the connection part
• Make sure that all knobs on the unit
are turned off. Make sure that the gas
supply is open. Prepare soapy foam
and apply it onto the connection edge
of the hose for gas leakage control.
• Soapy part will froth if there is a gas
leakage. In this case, inspect the gas
connection once again.
[D
Important
Never use a match or lighter to
make the gas leakage control.
DANGER
Risk of explosion by damage of
the safety tube!
The safety tube must not be
clamped, bent or squeezed or
come into contact with hot parts of
the unit.
Connection to the mains supply
Important
This appliance must be earthed!
Our company shall not held
responsible for any damage
caused by the utilisation of the
product without ground socket.
DANGER
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The unit may be connected to the
mains supply only by an authorized
qualified person and the appliance
is only guaranteed after the correct
installation.
DANGER
Risk of electric shock, short
circuit or fire by damage of the
supply cord!
The supply cord must not be
clamped, bent or squeezed or
come into contact with hot parts of
the unit.
If the supply cord is damaged, it
must be replaced by a qualified
electrician.
The mains supply data must
correspond to the data specified on
the rating plate of the unit. The rating
plate is either seen when the door or
the lower cover is opened or it is
located at the rear wall of the unit
depending on the unit type.
The supply cable of the product must
correspond to the specifications; see
technical data table Technical Data,
page 5.
Important
The plug should be easily
accessible after installation (but not
above the hob).
Plug the supply cord into the socket.
13 I EN