CITIZEN CT-S2000L - Manual (Page 18)

— 15 —
InitialSettings
1 Communication condition DIP switch setting Memory switch OFF
setting method setting
2 Hand shake XON/XOFF DTR/DSR OFF
3 Bit length 7 bits 8 bits OFF
4 Parity check With parity None OFF
5 Parity selection Even parity Odd parity OFF
6 ON
7 ON
8 INIT Reset Invalid OFF
3.6 Setting DIP Switch
CAUTION!
When setting the partition to the slot for 58 mm or 60 mm paper roll, be sure not to set
it slanted.
DIP switch
Interface board
mounting screws
CAUTION!
When setting the DIP switch, DO NOT remove screws other than those for mounting
the serial interface board.
The DIP switch is present on the serial interface
board.
Remove the board fixing screws, take out the
interface board, and then set the DIP switch. The
function of each switch is as shown below.
3.5 Partition for Paper Roll
Selecting baud rate
Switch No.
6 7
2400 OFF OFF
4800 ON OFF
9600 OFF ON
19200 ON ON
1200, 38400, 57600 and 115200 bps can also be selected by a command, etc.
Switch No. Function ON OFF
Baud rate selection See Table below.
Baud Rate (bps)
Partition
At the time of shipment, this partition is set to “80-mm
wide roll paper position”.
1. Confirm that the power switch is OFF.
2. Open the printer cover.
3. Set the partition to each to the slot which
meets the width of the paper roll used. When
using the 83-mm wide paper roll, remove the
partition.
4. Change the setting of paper width by reffering
to the section 5.2, "Manual Setting of Memory
Switch".