CITIZEN CT-S2000L - Manual (Page 16)

— 13 —
3.2 Connecting Interface Cables
Confirm that the power switch is OFF and connect the interface cable.
Orient the interface cable terminal correctly and insert it into the interface connector.
Printer
Pin Signal
2 TXD
3 RXD
4 RTS
6 DSR
7 SG
20 DTR
PC
Signal Pin
FG 1
TXD 2
RXD 3
CTS 5
DSR 6
SG 7
DTR 20
CAUTION!
■ For the method of using the Ethernet interface, refer to Separate volume.
■ When disconnecting the cable, always hold the connector.
■ Be careful not to insert the USB interface cable into the cash drawer kick-out connector.
Serial Interface Parallel Interface
For serial interface cable, use the one with the following connection.
Printer
Pin Signal
1 FG
2 TXD
3 RXD
4 RTS
6 DSR
7 SG
20 DTR
PC
Signal Pin
RXD 2
TXD 3
DTR 4
SG 5
DSR 6
CTS 8
USB Interface
CAUTION!
Avoid locating the interface cable in places which may cause tripping or falling.
25-pin - 25-pin cable 9-pin - 25-pin cable
Cash drawer
kick-out connector
Cash drawer cable
connector
3.3 Connecting the Cash Drawer
1. Confirm that the power switch is OFF.
2. Confirm the top and bottom of the cash drawer
cable connector and insert it into the cash
drawer kick-out connector at the back of the
printer.
3 Screw the cash drawer's ground wire to the body
of the printer.
CAUTION!
DO NOT connect any other device than the specified cash drawer to the cash drawer
kick-out connector. (DO NOT connect a telephone line either.)