VeriFone Vx570 - Manual (Page 19)

POS Start Guide
Jan 2013 18 VeriFone Functions
Vx610
Quick Start
1. The Quick Start is an easy way to setup up the VeriFone Vx610 terminal.
2. Connect the power connector into the power port on the side of the terminal, and
the power cable into the power pack. Plug the three-prong power cable into the
power outlet or use the provided car charger and plug into a vehicle power
source.
Note: First time charging, please allow the device 6 hours to charge completely.
3. After the device has charged it will display the VMAC main menu. Wait 60
seconds and Press the “F3” key to enter the eMedNY application.
4. Enter your National Provider Identifier(s) (NPI) or MMIS Identification Number(s)
(A typical providers only). Refer to the section on Instructions for Setup Menu (P1
Key) of this manual.
5. If you are using the device indoors and have it connected to an analog telephone
line and are required to dial a number to get an outside line (e.g. ‘9’), Refer to the
section on Instructions for Setup Menu (P1 Key) of this manual.
6. Press the F4 key or swipe the CBIC card in the Magnetic Card Reader to begin
processing transactions to eMedNY.
Connecting/Removing the Battery
1. Locate the Battery in the box the terminal was shipped in.
2. Connect the Battery as shown in the illustration below.