How to use your tiller, Stopping (see fig. 5), Tilling – Poulan 163760 User Manual
Page 8: Tine operation (see fig. 5), Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
The operation of any iilier car. recoi
1
1
i ‘^рун, ob;i
t=
¡n ft -
f s*fCT?GussB j lesuit in severe eye damage. Alwr /s л/еа*' з‘"‘у gf e« c»r ey .lei i' t, i
your tilier and while tilling. We
t
•'■ irriit-io > w t-
j K t t r t o . c . i - i J
,t« > f r
spccfacies or standaid
e
i. fy q> f -*
> v i
t
)ге starting
>r over the
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and oil
or attempting to start engine.
STOPPING (See Fig. 5)
TINES
•
Release forward tine
c o n t r o l t o
stop forward move
ment.
•
Release reverse tine control to stop reverse move
ment.
ENGINE
•
Move throttle control to “STOP” position.
•
Never use choke to stop engine.
TILLING
The speed and depth of tilling is regulated by the position
of the depth stake and wheel height.
The depth stake should always be below the wheels for
digging. It serves as
a brake to slow the tiller’s forward
motion to enable the tines to penetrate the ground. Also,
the more the depth stake is lowered into the ground the
deeper the tines will dig.
DEPTH STAKE (See Fig. 6)
Adjust depth stake by removing the hairpin clip and clevis
pin. Change depth stake to desired position. Replace the
clevis pin and hairpin clip.
•
For normal tilling, set depth stake at the second orthird
hole from the top.
WHEELS (See Fig. 6)
Adjust wheels by removing the hairpin clip and clevis pin.
Change wheel position. Replace the hairpin clip and clevis
pin.
•
Fornormal tilling, set wheels at the second orthird hole
from the top.
TINE OPERATION (See Fig. 5)
FORWARD
•
Squeeze forward tine control to handle.
REVERSE
•
With forward tine control “OFF” (up) position, pull back
and hold reverse tine control.
8